/
IO-Link master mode

IO-Link master mode

In master mode iqInterface can be connected to other IO-Link device to perform standard IO-Link master actions. You can configure master system manager parameters (cycle time, device check level etc.) and setup data storage. After configuring the master you can change IO-Link operation mode (inactive, preoperate, operate, auto), receive IO-Link events, set/get process data and read/write ISDU parameters. You can also record macro actions sequences to replay them automatically at once. To switch into master mode:

  • disconnect iqTool from iqInterface if connected (see PC connection)
  • select “iqMaster” tab and connect iqTool to iqInterface again

Related content

Master mode
Read with this
IO-Link generic device mode
IO-Link generic device mode
More like this
Direct mode
Read with this
Device Configuration
Device Configuration
More like this
Installation guide
Installation guide
Read with this
iqTool Application
iqTool Application
More like this